i.Trek M7 Bluetooth GPS Receiver

Advertisement





(sponsor)

INTRODUCTION

    A number of Bluetooth GPS receivers based on the MTK chipset
have been coming to market. The i.Trek M7 is one of them, claiming long battery
life and fast signal acquisition times. How does it stack up to its claims?
Read on to find out!

WHAT’S HOT

    Here are the key features of the M7:

  • 51 channel MTK chipset
  • Dual Bluetooth/USB interface
  • User configurable update rates
  • Auto on/off capability
  • WAAS enabled

SETUP


   

(all images link to higher resolution)

    The i.Trek M7 GPS comes with a USB cable, car charger, manual, software CD,
battery and a mounting pad.

    Setup is straight-forward. The GPS should be plugged into a USB
port or car power adapter for charging. Though the battery had some initial charge out of the box,
it reached a full charge in a couple hours. The battery indicator light on the top of the unit
glows green during charging and begins to flash when fully charged.

    The software CD can be used to install a Windows USB driver for communicating
with the GPS and a GPSview application for configuring the device. You will need to use the Windows
Device Manager to determine which serial port has been assigned to the GPS before using the GPSview
software.

    Setup on a phone or PDA will vary depending on the device, but should follow
the typical procedure used for configuring any Bluetooth device. The M7 is identified as “iBT-GPS”
and uses the usual ‘0000’ Bluetooth passkey.

    The i.Trek M7 does not install navigation or tracking software, so you will need
to purchase that separately or use one of the free software applications available on the internet,
such as Google Maps for Mobile or
Windows Live Search, or a premium solution like OnCourse Navigator.


PRODUCT FEATURES

    The i.Trek M7 is roughly the size of a small cell phone
making it convenient to carry in a pocket or purse.


Three LEDs on the top of the M7 indicate signal fix (yellow),
Bluetooth status (blue), and battery status (green).


A USB port on the right side of the device is used for charging
the Li-ion battery. A 3-position slide switch on the left side
turns the device on and off. The USB position is used when
connected to a PC to communicate with the GPSview software.


The GPSview software does not provide any useful information for
tracking or navigation purposes, but it will allow you to see detailed
satellite information or raw NMEA data.

    On a PC, the information found in GPSview would probably
be most useful if you were having trouble acquiring a GPS signal or
suspected there were problems with the GPS unit. If you were having trouble,
you could at least confirm the GPS was working and narrow down problems
to a Bluetooth connection or other problems with navigation or tracking
software.

    A sticky mounting pad makes it convenient to place the GPS in a
car windshield without needing to worry about it sliding around the vehicle.

    The most important aspects of any mobile GPS device are probably
its battery life, accuracy and time to acquire a signal. Battery life for the M7
was very good. i.Trek advertises 15-hour battery life between charges, but during
testing, I actually had the battery last 16 to 18 hours at times. Assuming you will
leave home with the device in the morning and return in the evening, you should have
plenty of battery life to last the day and recharge at night. If you only need the
GPS for car navigation, you can make use of the car charger and simply leave the M7
turned on. The auto on/off feature will automatically turn off the device when it loses
its Bluetooth connection and turn it back on when the Bluetooth connection returns.
In this situation, battery life becomes a non-issue, but there’s plenty of life available
for occasionally removing the GPS from your vehicle.

    Because the i.Trek M7 is WAAS-enabled, it is able to make use of
additional ground-level GPS signaling to improve accuracy (at least in the US). Signal accuracy is more
than sufficient for automobile navigation and should be fine for geocaching as well.

    As for signal acquisition, the M7 really performs well in this area.
Signal acquisition always takes longer when the GPS is started in a new location
or after being turned off for an extended period of time (cold-start) versus being
turned off and back on in the same location (hot-start).
Typical acquisition time for a cold-start signal fix is advertised as 36 seconds and
I found this to be accurate, averaging right at 38 seconds. Hot-start signal acquisition takes less than a second.
Comparing cold-start of the M7 with my handheld Garmin GPSMAP-60Cx, the Garmin device can take
more than two minutes for signal fix. (The Garmin uses the Sirf Star III chipset instead
of the MTK chipset.)

    I was very pleased with the i.Trek’s battery life, accuracy and signal
acquisition time. It should meet or exceed these aspects of any comparable products and the
auto on/off feature is a welcome addition.





(sponsor)

HELP SUPPORT

    i.Trek does offer e-mail support for its GPS devices and places its manuals online. Some
resellers may also offer support for the M7. For example, Semsons & Co. provides a
support page with e-mail contacts as well as
links to GPS forums and free GPS software.

SYSTEM REQUIREMENTS

    The i.Trek M7 can be used with any Bluetooth-capable cell phone, laptop or other device.
You will need additional tracking or navigation software to actually use the device. Fortunately, you can
use free software, such as Google Maps for Mobile or Windows Live Search, on Windows Mobile devices.
Configuration of the M7 requires a USB connection to a desktop or laptop PC.


BUGS AND WISHES


   
Configuring the M7 requires a USB connection to a PC. I’d like to be able to
configure the device over my phone’s Bluetooth connection as well, eliminating
the need for a PC connection altogether.

    The only software included with the i.Trek is the configuration
program. This software does allow you to see signal information, etc. but it would
be nice to have some additional navigation or tracking software included. (Some
i.Trek resellers will offer a GPS/navigation software bundle, but if that’s what you’re
wanting, you’ll need to make sure you’re purchasing a bundle package and not just the GPS.)

    The included mounting pad is a very nice addition for placement of
the device in a vehicle. Though the device conveniently fits in a pants pocket, it would
be nice to have a belt clip option as well for use of the device apart from driving.

PURCHASING

   
The i.Trek M7 is available
from the Semsons.com store for $59.99, which is a discount of 33% from the usual price. For an additional 10% off, use coupon code "pocketnow."


  • Very fast signal acquisition


  • Great battery life


  • Convenient, pocket-friendly size


  • Grip pad for vehicle placement


  • Auto on/off when used with a car charger

CONS


  • Lacks belt clip


  • Requires additional software for tracking or navigation


  • Lacks data logging features of more advanced devices

Value
Ease
of Use
Features

Overall

OVERALL IMPRESSION

    The i.Trek M7 is an easy to use Bluetooth GPS. It provides strong battery life
and fast signal acquisition which are key features for any Bluetooth GPS device. The M7 won’t provide
the additional data logging features of a more expensive unit and doesn’t include tracking or navigation
software, but it is a very reliable GPS and worth considering if you’re in the market for a GPS device.

Share This Post
Advertisement
What's your reaction?
Love It
0%
Like It
0%
Want It
0%
Had It
0%
Hated It
0%
About The Author
Legacy